KTM Cone Interface:

The KTM Cone interface is a tapered cone shaped hole on the top and bottom of the triple clamp (a cross section would look like an hour glass). The 2023+ version is identical to the 2016-2022 version, except it includes a counterbore for a flange on the top. Our bar mounts fit either version: they do not interface with the flange cutout, but rather the cone surface as it is more accurately machined and stronger. Triumph clamps use the same 2016-2022 KTM cone interface, though it is raised 5 mm above the top clamp surface. Stark Varg clamps also use the same 2016-2022 KTM cone interface.

---

Bar Size

The Nexus bar mounts fit standard 1 1/8" handlebars only (the most common size). Sorry, we do not offer the Nexus bar mounts in the FB36 (36 mm) size or the older 7/8" bar size.

---

Bar Position

Nexus mounts are the stock KTM height of 25 mm (bottom of bar to top of triple clamp) and offset (7 mm of bar position change when flipping the mounts around). This is the same as the Stark Varg. They are also the stock Triumph height of 30 mm (bottom of bar to top of triple clamp, including the 5 mm step in the triple clamp), but have slightly less throw front to back (7 mm vs. 9 mm with the stock Triumph).

---

Bike Fitment:

These mounts fit stock triple clamps with the KTM rubber cone interface, which includes many KTM, Husqvarna, GasGas, Triumph, and Stark Varg models, and all Luxon Gen2 triple clamps. Our mounts fit most bikes without issue, but in some cases, you may need to trim plastic brackets or relocate hour meters or accessories to allow clearance in the extreme mounting positions. Always check for full clearance after installation and before riding.

Most standard bar pads will fit with some trimming around the bar mount area. A Dremel tool with a sanding drum makes this easy, but a razor blade can be used as well.

An alignment tool is available here to ease installation and ensure correct alignment of the bar mount bases in the triple clamp. This tool is NOT required for installation, but makes the process a little easier and foolproof.

Stark Varg:

Nexus mount fitment on the Stark Vark requires relocating the phone; the phone cradle will not fit the Nexus bar mounts.

These bar mounts fit nearly all KTM/Husqvarna/GasGas big bikes, 2024 and newer. They also fit many older KTM/Husqvarna/GasGas big bikes, as well as Triumph and Stark Future bikes. The list below includes bikes that our mounts should fit; there may be more bikes not listed that our mounts will fit too. While the list is accurate as far as we know, mistakes can happen! Please double check that your bike has an KTM Cone interface as exlained above.