Our knuckle maintains stock ride height, increases holdup mid-stroke, and is more progressive near the end of stroke for more bottoming resistance. This allows for a softer setup to provide a more plush ride early in the stroke which better absorbs chatter and small bumps and increases traction. The revised motion ratio still provides better bottoming resistance than stock.

Bolt it on, check your sag and go. We recommend softening up your low and high speed compression and adjusting from there as needed. Precision machined from billet aluminum, black anodized, and laser etched. Includes OEM bearings and seals pre-installed and fits 2023-2024 KTM/Husqvarna, and 2024 GasGas motocross models.

Want an outside opinion? Read the MXA test and review of this knuckle here in our review section!

This knuckle is NOT compatible with some lowering links. It is compatible with our adjustable link arm, but heavier weight springs may interfere with the swingarm at the +3 or +4 mm adjustment lengths (all other lengths will work fine). Soft springs may not interfere at all (it's a tight fit at the swingarm and heavy springs are bigger).

KTM and GasGas Fitments

No linkage arm and no spring change required. Re-valve through @n2_dirt always recommended, but not strictly required.

Husqvarna Fitment

No spring change required. Re-valve through @n2_dirt always recommended, but not strictly required. This knuckle is designed around the KTM/GasGas geometry, so on a "10 mm lowered" Husqvarna, it will raise the ride height by about 5.4 mm in the rear. This can be addressed by using our adjustable link arm in the 2 mm longer setting (3 dots) to bring the rear end back down.