4-Post Rubber Isolated Bar Mounts, Stark Varg Cone Interface
Our lightweight 4-post bar mounts eliminate twisting due to small crashes and tip-overs without sacrificing vibration absorbtion like a solid mount would. Four sets of bushings absorb hard hits and track roughness without compromising steering precision. Three different rubber bushing sets (soft, medium, and firm) are included to fine tune the feel.
These bar mounts fit the Stark Varg and are intended to use the stock phone mount (top bar clamp) and pinch bolts. A Phone Delete option is available that includes pinch bolts and top clamps should you want to remove the Stark phone mount. NOTE: The Phone Delete option uses black bar clamps on the silver base as shown in the image.
Our bar mounts have the same bar position geometry as stock Stark Varg (height and offset). Handlebar size is available in standard 1 1/8" size only.
- $189.95 (Keep Phone Holder)
Product Description, Fitment, Information, and Details
Stark Varg Cone Interface:
The Stark Varg Cone interface on a stock clamp (click to enlarge)
The Stark Varg Cone interface is a tapered cone shaped hole on the top and bottom of the triple clamp (a cross section would look like an hour glass).
Fitment:
These mounts fit stock Stark Varg triple clamps with the rubber cone interface, which includes the Stark Varg motocross and enduro models.
Our Stark Varg Cone mounts fit the Stark Varg bikes. If in doubt, please double check that your bike has an Stark Varg Cone interface as exlained above.
- Stark Varg
- STARK FUTURE VARG 2023-2026
- MX 1.0, MX 1.2, EX
- 2023, 2024, 2025, 2026
Our Stark mounts are compatable (and require) the stock phone holder. The mounts are the stock height of 25 mm (bottom of bar to top of triple clamp) and stock offset (7 mm of bar position change when flipping the mounts around). Includes rubber isolated lower bar mounts, rubber bushings, high-strength steel mount bolts, anti-seize, and instructions (re-use your stock top clamp/phone mount and bolts).
Three different hardness levels of rubber bushings are included at no additional cost. Soft (green) is for lighter riders, vet riders, or those with wrist injuries. Medium (yellow) is recommended for most off-road and motocross use, and hard (red) is recommended for aggressive motocross use and faster riders.
Bushings will "break in" on the first ride and become a little softer than when first installed. Like all rubber bushings, these are wear items and will eventually break down and need replacing. Softer bushings will need to be replaced more often than harder bushings. Replacement bushings are available for a reasonable cost.
Installation video and instructions can be found on our customer page.
| Luxon Part# | LUX-SRK-SS-A0003-118 |
|---|---|
| Luxon Description | BAR MOUNTS, 4-POST RUBBER, STARK VARG CONE |
| Weight, 1 1/8" (excluding top mount and pinch bolts) | 321 g, 0.71 lbs |
| Stock Weight (excluding top mount and pinch bolts) | 235 g, 0.52 lbs |