M10 Direct Bolt-On Interface:

The M10 interface is a raised block on the top triple clamp, 20 mm wide, with multiple (two or three) 10 mm threaded holes per side. The bar mounts sit on these blocks and bolt directly to the triple clamp with an M10 bolt. These mounts fit many KTM, Husqvarna, GasGas, Sherco, Kove, and Beta Motocross, Off-Road, Enduro, Freeride, Adventure, Supermoto, and Street bikes that use the M10 interface. They do NOT fit the triple clamps with rubber cones in them or with unthreaded holes. If in doubt, contact us!

---

Bar Size

The Nexus bar mounts fit standard 1 1/8" handlebars only (the most common size). Sorry, we do not offer the Nexus bar mounts in the FB36 (36 mm) size or the older 7/8" bar size.

---

Bar Position

Nexus mounts are the stock KTM motocross height of 25 mm (bottom of bar to top of triple clamp) and offset (7 mm of bar position change when flipping the mounts around).

---

Bike Fitment:

Our mounts fit the vast majority of Motocross, Off-Road, and Enduro bikes without issue. In rare cases, you may need to trim plastic brackets or relocate hour meters or accessories to allow clearance in the extreme mounting positions (for example: front hole, bars away from the rider). For Supermoto, Adventure, and Street bikes, the mounts may interfere with the gas tank at full steering lock for the furthest back bar position (close mount hole, bars back toward the rider). Always check for full clearance after installation and before riding.

Most standard bar pads will fit with some trimming around the bar mount area. A Dremel tool with a sanding drum makes this easy, but a razor blade can be used as well.

Our M10 mounts fit 100s of bikes. The list below includes bikes that our mounts should fit; there may be more bikes not listed that our mounts will fit too. While the list is accurate as far as we know, mistakes can happen! Please double check that your bike has an M10 interface as exlained above.